"After application of white foil, exess white is left on the board."

The WhiteTRF film is a relatively "thick" pigment to try to cover solid black toner. Because of this, surface tension over the copper board start to play a part in holding onto areas of white so that when the foil's carrier is peeled back, you wind up with lots of excess white.

The simplest method is to use Scotch "Temporary" tape available at any stationary store. It is marked in a predominantly blue package and is very inexpensive. Just lay down strips directly over all white areas and peel back 180º over itself. This will lift off any and all white pigment that should not be there without damaging the white fused to the black toner image.

RETURN

 

If you don't find the answer to the problem you're having, please call us right away! We're here to get your problem resolved immediately!

Our hours of operation are from 9am to 5pm, Eastern Standard Time. Call (850) 926-2009. You can also email us at mail@pulsarprofx.com. If we are closed, leave us a quick email when you'd like us to call you back the next morning. Also tell us what TIME ZONE you are in so we don't call too early.